Getting Started

From Torque Wiki
Revision as of 08:11, 29 January 2011 by Ihawkins (talk | contribs)

These are the steps you will need to take when setting up the adapter for the first time. All of these following items can be done without the engine running on your vehicle, just the ignition turned to 'on'/'accessory'. Always make sure you are not putting yourself at risk when working on a vehicle.

A list of adapters that are known to work with Torque are available here

Initial Setup

First, locate the vehicle diagnostics socket - it should be a similar shape that will let the adapter plug into it. Some common places for it are underneath the drivers-side dashboard, or behind a flap near or underneath the steering wheel. Some vauxhalls/GMs have them placed in the centre 'tunnel' between drivers and passenger seats underneath the ash tray, and Alfas could be in the passenger glovebox. If you are unable to locate the connector, spend a moment to do a google search for it to save some time.

Once you have located the socket, plug the adapter into it. Some lights on it should light up. If you are using the PLX adapter, make sure it is turned on if it has a switch.

Now you need to pair the adapter with the phone. Some common pairing codes here are '0000' or '1234'. For older versions of Android, you may need to pair the phone 'twice'(check the notification bar for the pairing request after pairing for the first time).

Pairing the adapter with the phone is relatively simple:

  • Go to the phones bluetooth settings, accessible via the phones 'Settings->Wireless and networks->Bluetooth settings'
  • Scan for devices
  • Wait until the bluetooth device shows in the list - it should say 'scantool','obdkey','plx ...','cbt' or something similar.
  • Select the device, you will be asked for a pairing code, enter the pairing code for the device.
  • You are now paired. If you are using Android 1.5 you may get asked a second time (in the notification bar) to authorise the pairing - use the same pin code here as well.

Selecting the adapter with Torque

  • Launch Torque, and go into the applications settings menu
  • Scroll down the list of items until you see 'Connection Type' in the list. Make sure this is set to 'Bluetooth'
  • Scroll down to the bluetooth preferences section, select 'Choose Bluetooth Device' and select the adapter you paired with earlier.
  • Torque is now setup, and should connect to the adapter. To speed things up you might want to quit the app and restart it

Make sure your vehicle ignition is on (the engine does not have to be running) and Torque will start to read sensor information from the ECU. When Torque is properly connected, all the flashing icons at the top right of the main screen should turn blue and stay solid.