Arduino

From Torque Wiki
Revision as of 10:11, 15 March 2016 by Ihawkins (talk | contribs) (under construction)
⧼monobook-jumptonavigation⧽⧼monobook-jumptosearch⧽

Use your own Arduino(etc) based designs in Torque

There is a special protocol in Torque that lets you connect to devices such as the Arduino, Raspberry pi, and lets you feed the app your own sensor data. This includes allowing you to tell Torque what sensors are available

The example below uses an Arduino UNO, a generic bluetooth tx/rx module and a couple of potentiometers as example sensors. Torque will connect to the arduino, retrieve the list of sensors, then you can view them in the app!

TorqueArduino.png

Arduino Example Code

The example code that can be used with the arduino IDE can be found on the Arduino_code page. You can modify this code and customise it to your own requirements - just remember to define the sensors in the sensor list, and torque will then pick up the list of sensors.