Bluetooth Adapters

From Torque Wiki
Revision as of 06:08, 1 September 2012 by Ihawkins (talk | contribs)
⧼monobook-jumptonavigation⧽⧼monobook-jumptosearch⧽

This is a list of adapters that Torque has been tested with which work with OBD2 compliant vehicles:

(Note: All the adapters offer the same access to all the available OBD2 sensors in the vehicle. The adapters do not determine what sensors are or are not available, they are all the same in this respect)

Working Bluetooth & USB Adapters

Adapter Form factor Other features Cost(at time of writing) Comments
Scantool.net OBDLink MX
Scantoolmx.jpg
Small unit Power, Host, Bluetooth and OBD status lights, High speed PID reading

Device Security

$199.95 Flash upgradable firmware, Powersave/sleep function, Support forums

Reports of good customer support. This is the best adapter if you want the fastest PID read speed. Read speeds can be as fast as 60PIDs/sec over Bluetooth (Tested on a Galaxy S2, CANBUS protocol) This device also offers security to prevent unauthorized use

Scantool.net OBDLink
Scantool.jpg
Adapter and cable (adapter can be separated from cable) Rx/Tx Host<->ECU status lights $149.90(Special offer), $179.90 Normal Flash upgradable firmware, Powersave/sleep function, Support forums

Reports of good customer support. Fast PID read speeds, in excess of 60PIDs/second using a Motorola Xoom and USB

Scantool.net OBDLink
Obdlinksx.jpg
USB Adapter Activity/status light $49.95(Special offer), $74.95 Normal User upgradeable via free downloads, Support forums

Reports of good customer support. Fast PID read speeds, in excess of 50 PIDs/sec with USB to a Motorola Xoom tablet

OBDPros website
Obdpro.jpg
Adapter and cable (adapter can be separated from cable) Rx/Tx Host<->ECU status lights $84.95 + BT option at $74.95 = $159.90 Upgradable firmware

Support Forums

Diamex DX70 & DXM website
Diamex.jpg
Adapter in single unit RX/TX status light, Power Light 149EUR Not the fastest adapter, but good construction, reliable.
PLX Devices Kiwi Bluetooth
Plx.jpg
Adapter and cable (adapter cannot be separated from cable) On/off switch, link light $99.99 Support forums
Adapter from China/via ebay/amazon
Clone2.jpg
Single moulded unit (though there are several different coloured 'stickers' used) Rx/Tx Host<->ECU status lights $20.00 to $60.00 Some units seem to suffer poor build quality and reliability issues. Other units are perfectly fine. Make sure you purchase with a buyer who has a decent returns policy should the unit turn out to be defective. I would recommend avoiding this adapter if you intend to use it on a Ford vehicle which use the J1850-PWM protocol

If you are using the USB version of this adapter then be aware that you will need to make sure the adapter uses an FTDI or Prolific usb to serial converter chip and have an android device running Android 3.1 or 4.0(or above) and supports USB host mode

Adapters that are not currently supported

Adapter Form factor Other features Comments
Garmin EcoRoute Moulded plug attached to cable, not detatchable Works with EcoRoute HD navigation, "offline" data storage Non ELM327 compatible. The protocol was discovered, however the adapter proved to be too slow to be of any use.
GoPoint BT1 Moulded plug Non ELM327 compatible. Currently an unknown adapter protocol